Linear Home Security System AM KPI User Manual

1. INTRODUCTION  
2. KEYPAD FEATURES  
The Model AM-KPI keypad is designed for use with Linear’s AM/II  
access control system. The keypad is housed in a rugged, plastic  
enclosure and is designed to be mounted indoors in a standard single-  
gang electrical box. Tamper resistant screws secure the keypad to its  
mounting plate. The die-cast keys have bright, easy-to-read yellow  
graphics.  
RED/GREEN  
POWER/ACCESS  
INDICATOR  
YELLOW  
"LOCKOUT"  
INDICATOR  
AM-KPI  
BEZEL  
The keypad is supplied with a satin-chrome plastic bezel installed.  
Three interchangeable colored plastic bezels (white, ivory, & bronze)  
are included with the unit to customize the keypad appearance for the  
installation.  
Access  
Control  
Keypad  
SOLID STATE  
WHITE LED  
DOWN LIGHT  
DEVICE  
ADDRESS  
SELECTOR  
All system indicators and lights are long-lasting, solid-state LEDs.Two  
indicators show the status of the entry system. The left indicator lights  
red to indicate power, then turns green when access is granted. The  
right indicator lights yellow when the keypad is in “lockout” condition  
(from too many incorrect code entries). A white LED downlight lights  
the keypad for nighttime use. An internal sounder beeps when each  
key is pressed.  
FACEPLATE  
KEYPAD  
Installation  
Instructions  
The AM-KPI is normally powered from the AM/II controller. Alternately,  
the keypad can be powered locally with a 12 VDC power supply.  
Robust static and lightning protection circuits safeguard the keypad’s  
electronics.  
TERMINAL  
BLOCK  
A rotary switch selects the keypad’s device address. Each device  
connected to the AM/II must be set to a different device address.  
MOUNTING  
PLATE  
(760) 438-7000 • FAX (760) 438-7043  
USA & Canada (800) 421-1587 & (800) 392-0123  
Toll Free FAX (800) 468-1340  
3. OPEN THE KEYPAD  
4. CUSTOMIZE THE BEZEL (OPTIONAL)  
5. INSTALL WALL BOX & MOUNTING PLATE  
1
PRY UP ON THE  
FACEPLATE HERE  
TO CHANGE THE APPEARANCE OF THE KEYPAD  
TO BLEND IN WITH THE INSTALLATION,  
CHOOSE THE APPROPRIATE KEYPAD BEZEL  
INSTALL A SINGLE-GANG  
ELECTRICAL BOX AT THE  
PROPER LOCATION  
FOR THE KEYPAD  
REMOVE THE  
FACEPLATE  
2
KEYPAD BEZEL COLORS:  
SATIN-CHROME (FACTORY INSTALLED)  
KEYPAD  
BEZEL  
WHITE  
IVORY  
BRONZE  
KEYPAD  
ASSEMBLY  
MAKE SURE THE  
TAB IS UP  
MOUNTING  
PLATE  
3
ATTACH THE MOUNTING  
MOUNTING  
REMOVE THE  
TWO SCREWS  
THE BEZEL SNAPS  
ONTO THE KEYPAD  
ASSEMBLY  
PLATE TO THE  
ELECTRICAL BOX  
PLATE  
SEPARATE THE  
MOUNTING PLATE  
FROM THE KEYPAD  
4
 

Lennox Hearth Indoor Fireplace ELDV3530 User Manual
LG Electronics Telephone GDK 20W User Manual
Lightolier Indoor Furnishings 1004ICV User Manual
Linear Home Security System CCM 2 User Manual
Makita Cordless Drill BDF440 User Manual
Makita Portable Radio BMR100 User Manual
Marshall Amplification Stereo Amplifier JCM800 Series User Manual
Maytag Washer MAH3000AWW User Manual
Melissa Trimmer 238 100 User Manual
Metrologic Instruments Scanner MS7220 User Manual